Knowledgebase

The receipt printer is not printing

Receipts print from the EraPOS window on the store server PC, through the printer installed in Windows. Most problems come from printing in a browser tab, a printer name that does not match, or the printer driver's cutter and paper settings.

Symptoms

  • Nothing prints, or EraPOS shows Print failed!
  • A message asks you to Select an available printer before printing.
  • The receipt prints, but the paper is not cut.
  • The receipt prints very small.
  • The cash drawer does not open after a cash payment or with CASH DRAWER.

Likely causes

Printing from a browser tab
Only the EraPOS window, started with EraPOS.exe on the store server PC, can reach the printer. The POS opened in a web browser shows Print failed! instead.
The printer is off or not ready
No power, no paper, an open cover or a loose cable. The cash drawer plugs into the printer and opens through it, so it stays shut too.
The printer name does not match
EraPOS prints to the printer named in the register's POS profile. That name must match the printer's name in Windows exactly.
The cutter is switched off
Some printer drivers come with cutting turned off. On Xprinter models, the driver setting Cutter select can be set to Report[No Cut].
The size does not match the paper
The receipt layout or the driver's paper size is set for a different roll, so the receipt comes out scaled down.

Fix

  1. Print from the EraPOS window

    On the store server PC, open EraPOS with EraPOS.exe and print from there, not from a browser tab.

  2. Check the printer in Windows

    Check power, paper and cable. In Windows, open Settings > Bluetooth & devices > Printers & scanners, choose the receipt printer and print a test page. If Windows cannot print, reinstall the driver from the printer's maker first.

  3. Match the printer name

    Open MENU > Administration > Device Profiles > POS Profiles, open this register's profile and make Printer Name exactly the name Windows shows. If you cannot save the change, EraPOS support can make it for you.

  4. Turn on the cutter

    In the printer's properties or printing preferences in Windows, find the cutter setting. On Xprinter drivers, set Cutter select to Report[Cut], which cuts at the end of each receipt.

  5. Match the paper size

    Open MENU > Administration > Print Settings (it asks for a full-access password, such as the owner's). On Print Layout, under Print Config, choose the Printer Model for your paper: Epson 80mm for 80 mm rolls (also for HPRT, Xprinter and Volcora) or Epson 58mm for 58 mm rolls, then choose Save change. In Windows, set the printer's paper size to the same roll width.

  6. Print a test

    In Print Settings, choose Print test.

Result

The test receipt prints at full width and is cut, and receipts print at checkout.

Still stuck?

Note

Open a support request with your printer's make and model, whether the Windows test page prints, and the exact message EraPOS shows. To set up a printer from the start, see Connect a receipt printer and cash drawer.

Was this answer helpful?

Related Articles

Powered by WBAMS